Wait/Walk signals at Atwater and Woodlawn are confusing. Unless someone happens to press the button before the light changes, the wait signal stays on the whole time. Foreign students get especially confused. The 3rd and Woodlawn wait/walk signals can also be confusing, but are not nearly as bad.
Cannot see 'red dot' of traffic signal at 3rd and Woodlawn. Difficult to cross street.
Hi, I contacted the city last week about a stop sign on 2nd and Ballantine that is completely covered by a tree. It is a danger as it should be a 4 way stop, but people don't see it and will fly through it. Please get the tree trimmed so it doesn't cover up the stop sign. Thank you. Best, Ingrid
Caller from The Project School reported that the lights at the crosswalk at the intersection of Smith & Washington aren't working. The lights don't flash to allow pedestrians (their students) to cross. Thanks for looking into this.
Missing street name signs, and knocked over school zone sign. The school sign I straightened as much as possible but it seems to be just stuck in a dirt hole. So leaned again right away.
Stop sign knocked down at se corner of Highland and 2nd St
Ped signal at Smith and Washington is triggering erroneously a couple times per minute. Not sure if the rain is causing this or what.
I often bike north on Jordan avenue to 3rd St., then turn left onto 3rd with the traffic light. Before the recent construction, the left turn signal appeared to be on a timer, and now it seems to be activated by a metal-sensitive loop in the pavement. But so far I have been unable to trigger the left turn signal with my bicycle. I have been instructed to ride exactly on the wire, and I ride a steel frame bike from 1970, so it should have plenty of metal to be detected. Is there some way to make sure this traffic light actuator is sensitive enough to work for bicyclists as well as for cars?
Not really a "Traffic signal" but I couldn't find a "Sign" category: The "No Parking" sign in front of 1300 E. Southdowns Dr. was rammed and damaged by a fast-moving hit-and-run white panel truck at 2:30 pm today, 5/28/2014. Sign was bent and is now leaning. I heard the noise, saw the truck driving past, but did not notice identifying markings on the truck -- it may have been solid white. It had to be driving on the grass to do this damage.
Walk signal for pedestrians crossing aAtwater at Henderson is off and dangerous, restricting crossing when it should and encouraging crossing when it shouldn't. I've seen at least one close call. Please fix this! Thanks