The left turn signal for south bound traffic on high st always comes on, even when there are no cars in the turn lane. This delays the north bound high st traffic, especially in the morning when it may take 3 light cycles because this malfunction.
The traffic light on Patterson goes red after 1-3 cars pass through. This happens over and over again even though there are no cars on Farview. I have waited upwards of 7+ light cycles to get through this light. This delays drivers and increases pollution. This has been an issue for months, please fix the issue.
The turn light on eastbound 3rd street going onto N. Gates Dr. stays on even when there are no cars turning.
The stop light on weekends is messed up. It only stays green for about 6-7 seconds for traffic using Patterson. Changes without anyone even pulling up on either side of Fairview
Patterson and Fairview light timing messed up. Constantly switching to red after about 10 seconds even with no traffic waiting on sensors
The sensors are not working properly. Early in the morning, when there is no traffic, I will often sit on college mall road heading north for 2+ minutes. It runs through the entire cycle including crosswalks...even if no one else is at the light. There are now often many cars backed up at the light. It is very in efficient. Thanks for your help!
The traffic light is down and it caused a huge traffic
Traffic light out of sync
Signal out of sync
Pedestrian crossing does not switch to “walk” and hasn’t for a month. 2nd and College Mall Rd, Eastland Plaza intersection with College Mall Rd., East 3rd St and Pete Ellis Dr, East 3rd St and street next to Bloomingfoods