Water struggles to get around e Morningside and n Sheffield without pooling. Any chance curb can be built up a bit there or the cement can be shaved a bit to let the water keep flowing by? Thanks!
Hey, all. I'm at 4021 E. Morningside Drive. Unfortunately I've been experiencing some drainage issues at my corner since the installation of a wheelchair ramp for the sidewalk. There was no issue prior. Terrific having the ramp for folks, plus the earlier sidewalk, but unfortunately it has no lip on it at all. As you can see in the photo, the street is essentially level with part of my yard now, allowing even the smallest rain to flood the corner. I'd love to grow grass but am having difficulties because of the situation. There was grass prior, but someone crashed into the streetlamp, and when it was replaced, the ground got torn up a bit. Beyond my yard, a small pool exists along the corner until it dries out as well, as it is unable to pass on through. Also sediment as you can see in the photo (taken tonight a few hours after the end of today's misting) is washed into the street with each rain. Please see if there can be just the smallest bit of lip and/or incline added with the ramp/sidewalk to keep the water moving instead of creating a muddy corner. Thank you for any help! (Or ideas!) Any chance you all might have a square foot of sod that is fairly water tolerant that can just be placed down there? Might solve my issue without any need for changing anything with the concrete assuming it takes root. I appreciate the consideration and help. There is also a bus stop right at the corner, so more than just helping me, it keeps the bus waiters from standing in the mud.
fiber optic crews have broken out two large chunks of the new curbs installed a few years back to control water run off. I am concerned that these unseated and cracked curbs will cause further water damage that you just fixed. south of 426 e blue ridge dr. is the location and my address. I think the fiber optic people should be fixing this and not the city needing to come back to fix it again. thanks