Feerwood Ct and Ironwood Ct street signs are misprinted as Feerwood Dr and Ironwood Dr, and the Tulipwood Ct sign was not replaced when those signs were and has become difficult to read by comparison. This causes confusion for people not from the area who are unable to find the right street since the signs are wrong.
Shale Crest Dr. Street sign needs to be replaced
Stop sign is laying on the ground
Stop sign on Buick Cadillac Drive at Clarizz blocked by leaves/limbs.
The stop sign is partially covered by shrubs and they need to be trimmed. People run this stop sign all the time. Please make sure the stop sign is fully visible. On woodlawn headed NORTH at E Maxwell Lane and Woodlawn intersection.
The sign for "South Drive" at the intersection with Walnut has been hanging down, a bit askew, for a while. The sign is on the southwest side of the intersection, on the west side of the street light structure. You can still read it, but it is not properly attached.
On high street, heading south the light at hillside doesn’t turn green unless someone comes from the other side. If someone heading north turns left, the light doesn’t turn at all. The east/west light is much longer running as well.
The north-south light at High St and Moores Pike only is green for a couple of seconds, allowing at most two cars to pass through the intersection. Is it possible to adjust the timing on this light?
When heading north on Williamsburg from Washington it is extremely difficult to see the stop sign at Eastland Drive until you get past the visual obstruction caused by the last boulevard tree on the east side side of the road. Now that the leaves are beginning to fall the problem will go away until spring, however.