closed #166440
Traffic Signals
- Case Date:
- 11/7/2018
The light on Walnut St at Hillside facing south is going red for long periods with no turning traffic
The light on Walnut St at Hillside facing south is going red for long periods with no turning traffic
The light at Jonathan Dr. and Curry Pike needs adjusted. Turns green for Jonathan Drive when no one is there. Especially early in the morning.
blinking red lights
Missing street name signs, and knocked over school zone sign. The school sign I straightened as much as possible but it seems to be just stuck in a dirt hole. So leaned again right away.
The left turn arrow for southbound Walnut Street at Hillside Drive is activating even with no traffic in the lane. Stays on for a full left turn cycle.
Signal for turning left from north bound Curry Pike to Gifford Road comes on even if noone is there.
at walnut and winslow, the left turn arrows are not activating for any of the four directions.
Leaving lot for Fresh Thyme/Big Lots and attempting to turn left (East) on to 3rd St, current signal timing only allows, at best, 3 vehicles to proceed through the light. With the configuration of that lot entrance, this results in substantial backups and blockages.
Many, many times over the last 6 months this signal has gone out or to a red blinking state. This is at the north bound on/off ramp for 37/69 and 3rd St. Given the current east-west corridor limitations, the added delays here are a frustration at best.
nw pedestrian crosswalk light is burnt out