closed #144004
Sidewalk & Curb Complaints
- Case Date:
- 3/11/2015
2 large potholes on northeast corner of fee and 11th
2 large potholes on northeast corner of fee and 11th
There are two potholes on South Walnut Street Pike that are deep enough that they've possibly cracked my wheel. I will be going to get it checked this week. The first one is in the south-bound lane just south of the Rhorer Road intersection. The second one is in the north-bound lane one mile (or less) north of Fairfax Road.
Multiple otholes on Liberty Drive, starting at W Third all the way pas the IU Health facility on Liberty; Terrible utility cut hole on First between Walker and Rogers; Pothole in front of the "Canadian Apartments" on First, between Rogers and College.
North bound on Walnut street right past 10th street, there's a good size pothole on the right lane. Also, on north side of the town, coming in to Bloomington on SR 37 Walnut street exit ramp, multiple potholes right after overpass bridge, these potholes have been there last couple months and they are getting worse, I had to drive on shoulders to avoid these potholes. Thanks.
There are a number of extreme potholes on the section of Smith Rd just south of Moores Pike until the bend where Smith becomes Rogers Rd. They're deep enough to require evasion or snail's-pace driving or risk bending axles and rims. There are a number of less severe potholes on the remainder of the road after it becomes Rogers.
Holes on north sides of calming circles on W. 7th Street. Seemed to really inhibit the emergency vehicles as they came up the street the other evening and those potholes have been really hard on my automobile.
Street entrance from W 3rd into Landmark on Westside of the street.
There are multiple deep potholes on Henderson, between University and Atwater.
The pedestrian crosswalk lights at 10th and Jordan are not turning to walk when it seems like they should be.
The pedestrian signals for the N-S crosswalk across Jordan Ave. on the west side of the 10th and Jordan intersection are not working. After pressing the button, the Walk signal never activates through multiple cycles. The small red lights above the buttons remain illuminated. I previously reported this two weeks ago on Feb. 27, so I wanted to make sure you were aware that this signal is still malfunctioning. I have seen (and been a part of) several near misses between vehicles and pedestrians that were at least partly a result of there being no Walk signal. Thanks for looking into this.