There is an unmarked meridian as you approach 3rd street going north on Clarizz. At night, it's difficult to see the concrete meridian because you are driving up hill. There needs to be a sign there, directing you to veer to the right.
When exiting neighborhood, drivers can not see oncoming cars from the left. It seems like a dangerous intersection that might require more study.
North-facing Speed limit sign reads "30" at this location; however, on Woodlawn at 7th, a south-facing speed limit sign reads "25." Checking Bloomington Code, this stretch of Woodlawn Ave does not appear in Schedules I or J—thus making the speed limit 25 mph by 15.24.010 and IC 9-21-5-6. "Speed limit 30" sign on Woodlawn just south of 10th should be corrected to read "Speed limit 25."
Please investigate extending left turn signal length from Patterson Dr to 2nd St, seems really short (only 1-3 vehicles allowed to turn)
I hope I can coherently explain this. If I don't effectively convey my complaint, please call me. I work for IU Campus Bus Service. I've noticed that the pedestrian crossing signal for peds crossing Fee Ln on the north side of 10th will stay on the "Walk" signal during the transition from 10th St having a green light to an all red (to allow peds to cross in all directions). The problem with this configuration is that a vehicle can effectively get stuck in the middle of the intersection if it was waiting to turn left/north onto Fee from Tenth, while partially in the intersection. In this situation, vehicles can either block the intersection or attempt to squeeze through pedestrians crossing on the north side of the intersection. As you can imagine with a bus, this is a dangerous dilemma.
Stop sign needs to be replaced
I suggest posting "no turn on red" for west bound traffic turning onto Range Road. Because of the cement barrier and narrowness of the road I have twice had cars interfere with and almost run into me as I try to make a left turn onto 10th St. on the green light.
Some signage or road surface markings would be useful at the intersection of 10th St and Pete Ellis/N. Range Road. The specific problem is when you're heading north. Pete Ellis has basically two lanes at the light. I'm not sure if there are any lane markings, but that's how everyone treats it. However there is confusion on what the lanes are there for. Most people treat the left lane as forward/turn-left, but some think the right lane is forward/turn-right. This becomes a problem when drivers in both lanes decide to go forward onto North Range Road, which has just two lanes. Because Range Road now has an outlet, it has seen more use in recent years, which is sure to increase even more when the hospital goes in. As such, I've either had or witnessed numerous close calls as people nearly sideswipe each other trying to go straight. It would be nice if there was signage indicating specifically what the lanes are there for. My suggestion is the left lane should be forward-left turn and the right be right turn only. Either that or some lane markings and arrows on the pavement itself.
Over a month ago I reported the street signs missing at the SE corner of Stull Ave and First St. They are still missing and now the signs (and the sign post) at the NE corner of Stull Ave and Maxwell Lane are missing as well. Could you please look into this matter?
The white strips on Rogers Street and Dodds Street indicating where cars are supposed to stop are worn out. Drivers have a habit of driving through the intersection without stopping and drawing more attention to the stops would be beneficial. The stop signs could also have a reflective strip on them to draw more attention to them. 1st Street and Rogers could also benefit from the same improvements.