The intersection of 11 and Forrest currently is a three way stop. I would prefer if this was a 4 way stop. I frequently travel between the buildings on the NE and the SW corners. It would also be helpful to have stop-lines/cross walk lines once construction is finished in the SE block.
The stoplight at the corner of S. College Mall Rd. and E. Buick Cadillac Blvd is quite dangerous. I live in Hunter Ridge apartments and when I leave the complex at the light in that intersection, I'm regularly almost hit by cars coming from the opposite side of the intersection (near Burger King). When I try to go straight through that intersection, as I have the right-a-way, those cars turning left regularly cut me off. The same often happens when I try to turn right. I would strongly suggest putting in a left turn arrow on that Burger King side of the intersection; someone is going to be severely injured if not. Thank you.
With the prolonged closure of W17th St, is it possible to change the pavement markings on Crescent Rd at it's intersection with Fountain Dr? Eliminating the left turn lane on Crescent Rd, leaving just a single lane on Crescent Rd would greatly improve the turning radius from Fountain Dr onto Crescent Rd. With the construction of I69 there is very minimal traffic turning right from Crescent Rd to Fountain Dr, not enough to justify a dedicated lane. Thanks!
I frequently travel N and S on Hunter, and it is very, very difficult because of street parking to see whether there is oncoming traffic at this Woodlawn intersection. (There are other similar situations in the neighborhood, but this one is particularly bad.) it would be wonderful if there were convex traffic mirrors to be able to see around the corner. These are commonly used in low-visibility corners in Europe, and can be highly effective.
The intersection at north 10th, Smith road, and Russell road is one of the most dangerous in Bloomington. I believe there needs to be a traffic light there to allow people to turn from Smith Road. It's almost impossible for drivers coming off Smith Road to turn either right or left onto 10th or Russell, especially during rush hour traffic. Visibility is poor because 10th street curves in unusual ways at that intersection, and none of the two-way traffic wants to yield. Bus traffic from 10th Street compounds the problem. Thanks for helping!!
The intersection of Smith road and 10th Street has heavy traffic, especially in the morning and during the rush hour. The fact that there is university elementary school nearby the intersection makes the traffic heavier at times. However, the intersection is controlled only by one way stop sign. The fact that around the intersection the road on the 10th Street curves makes the traffic coming from Smith road challenging to turn on the 10th street. I strongly recommend putting traffic lights on that intersection to avoid accidents and relax the traffic around the intersection.
I would like this intersection to be "No Turn On Red" for northbound traffic, and possibly have a few seconds delay for pedestrians/bikes to cross before the light turns green. It's dangerous to have cars hooking around bikers in the bike lane trying to go straight across. Thanks!
The lights at intersections need re programmed so that a green light happens in sequence. The cars can’t progress because the light stays red for 10 seconds while the eastern intersections light is burning green. The cars can’t travel anywhere. Very frustrating!
Looked like E Morningside through Park Ridge is at 20 mph but Park Ridge East is at 25 mph. Can you make consistently 20 throughout? Thank you. Both remain residential areas, bike path, and such.
Please consider adding a stop sign at the intersection of Highland and the street leading into/out of the YMCA property. Curving road, ascending and descending roads, blocked views, speeding cars, pedestrians and children. Need a safer way to cross and turn at this intersection. Thank you