Just a question regarding the signal at 10th and the Bypass, specifically when a train is passing, just south of the intersection: why is eastbound traffic not given a green light? It makes sense that southbound traffic at that intersection shouldn't get a green light until the train has passed, but I'm uncertain why traffic on 10th, heading straight east, is held up when there's a train. Thanks!
Traffic light for Wynnedale cycles through even though there isn't anyone there causing traffic to backup over the bridge in the mornings and to back up to Landmark in the evenings. This morning a car was stopped going eastbound on 3rd street just seconds after the light turned red to make a left turn onto Franklin, they did not get the arrow. There wasn't anyone turning left westbound but that traffic got the green light while eastbound traffic had to wait. The issue with the light cycling through for the Wynnedale traffic has been ongoing for at least 2 weeks.
To turn right off Kimble onto West 3rd Street going west you sit through at least 7 traffic lights. Cars continue through intersection going west and you cannot pull onto 3rd Street when u have the right away from other vehicles blocking intersection illegally. the lights are not timed correctly and it is a major problem
The light is green for too long for south/north facing traffic. I have observed multiple instances there are no cars, but traffic will be backing up in east/West lanes. Westbound has it particularly bad as the traffic will start backing up past the Cory Lane intersection as a result of this light-once I make it past this intersection traffic flows so much faster.
The light signals at this intersection are not working properly. The green arrows always run even if there is not any cars turning. This is causing many backups during the day.
The pedestrian walk signal to cross 10th street at this intersection is not functional.
L turn signal does not work to turn Left onto 10th street from union
People are reporting Walnut/Hillside signal stays green for Walnut for very long times, backing up Hillside Drive until someone turns right on red illegally, which seems to trigger the signal. Is this City or State problem?
Walk light does not turn on to cross S Henderson St. That’s going west on E Winslow Rd using the sidewalk on its south side.
Yesterday and today, the light at 10th and Fee has been malfunctioning. A bus driver reported to me that the southbound Fee Lane light seemed to skip a cycle and she had to wait 5 minutes before getting a green arrow to turn onto 10th. Several cars were waiting, so the magnets should have been tripped. I'd greatly appreciate someone checking on this. Thanks! Haley Bandy, IU Campus Bus Supervisor