Light for 37 south exit onto 2nd Street timing seems off. I find myself waiting to turn on to 2nd Street for minutes, often for up to 40 seconds without cross traffic. It is common to have the light red without cross traffic and then turn green just as cross traffic arrives. Anyway, it does not seem correct.
Traffic light at 3rd/Kingston ( College Mall / Speedway Gas ) needs traffic sensors. Early morning (6-7:00am) the signal will cycle through cross street and turn lanes with no vehicles in those lanes, can take up to 2 full minutes waiting on the light with no other traffic at the intersection. Morning commuter traffic flow on SR46 is unnecessarily hampered at this light.
Westbound on bypass left light is not functional
Heading West on 46 the first stoplight the green light is out.
The traffic light at 10th and Woodlawn Avenue has started flashing red.
I have noticed multiple times when trying to cross the street at Smith & Walnut that the pedestrian walk signal does not seem to always be synced properly with the traffic light. The walk light often does not turn on when the traffic on Walnut is stopped at the light. It is incredibly confusing and concerning as it is a place where children often cross with The Project School and Rhino's being near by. If someone could take a look at it, it would be greatly appreciated. Thanks!
Traffic Light on 45 at the Rural King/Sam's Club intersection is only working on a timer vice automatically sensing and responding to actual traffic conditions. Time Observed malfunction 0530 to 0630.
2 young men at 6:30 this morning were taking down the Stop Sign at 2nd and Mitchell. I asked them to stop since I said taking it down would be dangerous. They said okay and seemed under the influence of influence. After I walked my dog, I returned to the corner and the sign was gone. This is clearly a danger issue. It is a 4-way stop but highly transited.
Traffic light timing is way off, only letting 2-3 cars through before turning red again. The turn lane from Patterson into 3rd has been backed up quite a bit, this will likely cause delays in traffic this coming week due to 2nd st lane closures
Both Mon. and Tues. (today) the wait to get through the light at E Moores Pike and High Street was extremely long. I travel west on Moores Pike/Hillside every weekday between 8:30am and 9:00am. Today the traffic was backed up all the way to the Moores Pike Roundabout. It \probably took at least 5 cycles of the stop light before I was through that intersection. Note: The last time I reported a similar situation at this stop light, it was a bad sensor. Thank you.