The signals do not switch the lights when traffic is stopped in an east -west direction but no traffic is going is traveling in the north-south direction. Either the sensors are not working or the electronics is at fault.
The walk/ don't walk sign at 3rd and Rogers, on the northwest corner, is obscured by leaves and virtually invisible. Thank you.
Stop sign here (South Renwick, heading east) is blocked from sight by the trees. Very hard to see until you are almost in the intersection with South Hawksmoore.
The left turn light for southbound Walnut at Hillside is activating with no traffic in the turn lane and stays activated for the maximum timing. This has been ongoing for a few weeks now.
the traffic light at the corner of high street and hillside drive (moose's pike) needs fixing. going south on high street, the arrow to go left (east) onto moose's pike ALWAYS activates, with no cars there. it stays a long time, disrupting traffic in all directions.
On southbound High Street at Hillside, left turn traffice signal activated during every cycle, whether there is a car in left-turn lane or not. Sensors need to be checked, please, since traffic backs up needlessly.
For north/south traffic, neither left-turn arrow works. For traffic moving west, the left turn arrow always comes on whether or not there is traffic in that lane or not. I have not noticed a problem with eastbound left turn lane but that's not to say it doesn't have a problem as well. :)
Traffic light at eastern on/off ramps at W. 3rd and SR 37 is blinking red
I was waiting for green light signal at approximately 2:35 pm today (6/6/2017) from eastbound 10th St, but the green light changed to yellow light in less than a second.
The light at 2nd and High street is not working.