Case Date:

9/7/2020

When cars turn off of 10th st onto sunrise or in to the parking lot at teter quad, the light turns red for 10th st needlessly.

Case Date:

9/27/2020

Traffic light works, but then stops & starts flashing yellow going east & west. Landmark turning East or west gets flashing red.

Case Date:

10/6/2020

I have been at the stoplight heading north on S. Walnut St. at the Rhorer Rd intersection twice lately and the stoplight does not register that you are waiting on the light to change. There must be something wrong with the sensor at this light. Thanks!

Case Date:

11/2/2020

This is a test.

Case Date:

12/1/2020

The vehicle sensors on Clarizz don't seem to be detecting correctly. I have set at that intersection, and the traffic signals take a long time to change, even if there's no traffic on 3rd Street. Wasn't sure if that is the way it is supposed to be or not.

Case Date:

12/4/2020

Light bulb is out on the Pedestrian Traffic light. Bulb that is out is facing East.

Case Date:

1/9/2021

The light at High St and Hillside/Moores Pike has a left turn signal that is activating whether or not a car is present. It is the left turn arrow on southbound High St as you approach the intersection adjacent to the cemetery. This prevents cars heading north on High St from proceeding until the light cycles through the phantom left-hand arrow.

Case Date:

2/6/2021

Signal needs reset/repaired, it is flashing red in all directions

Case Date:

2/12/2021

Traffic signal flashing red all directions.

Case Date:

2/23/2021

The "walk" signals for crossing Third Street at High and Bryan Avenues never gave us the walk signal despite having pressed the pedestrian crossing buttons several times, and sitting through several cycles of the stoplight(s). This was both crossing Third Street heading north onto Bryan, as well as crossing Third Street south onto High.