Case Date:

10/30/2015

We were traveling east on 10th St. this evening, approaching the bypass on the east side. While waiting for the red light to change to green, the train gate on the bypass lowered and a train approached also from the east. When a train is crossing the bypass, the light rightly does not allow traffic through from the north, as it would soon have nowhere to go. This is good. BUT it also did not allow our lane to travel through the intersection going east! I know there is no separate right-turn signal there to stop people from turning south onto the bypass, but it is not logical to stop all traffic going east as well. And besides, the light DOES allow westbound traffic on 10th Street to BOTH continue west AND turn south onto the bypass -- even though there is a separate signal there for the south-turn lane -- and those cars then are stopped by the crossing gate. This is really illogical, and should be remedied.

Case Date:

5/30/2013

Green arrow for right turn going from westbound 3rd st. to north bound bypass when left turn for southbound bypass to eastbound 3rd st. is out.

Case Date:

7/2/2023

Traffic signal is flashing red in all directions.

Case Date:

7/31/2023

Turn signals trigger although no cars are in turn lane.

Case Date:

1/3/2022

The street light is out and is in flash.

Case Date:

12/1/2020

The vehicle sensors on Clarizz don't seem to be detecting correctly. I have set at that intersection, and the traffic signals take a long time to change, even if there's no traffic on 3rd Street. Wasn't sure if that is the way it is supposed to be or not.

Case Date:

6/19/2013

The pedestrian crosswalk buttons are not working properly at the intersection of 10th & Jordan this morning. In particular, the westbound crossing button on the southeast corner did not activate the pedestrian crossing light through several cycles at approx. 9:10am. I didn't confirm, but it looked like other buttons/directions were having similar problems. Was working fine yesterday.

Case Date:

9/23/2013

None of the pedestrian crossing buttons have been working at the intersection of 10th and Jordan today. There is no way to activate the pedestrian signals.

Case Date:

10/28/2013

10th and Jordan intersection: Westbound pedestrian crossing button on SE corner and northbound crossing button on SW corner are not working - red light above button remains on and walk signal is not activated. Problem has been happening for at least a week or so.

Case Date:

8/28/2023

The walk signal at the NW corner of 10th and Walnut facing south is burnt out. The don't walk signal lights up but the walk does not. Thanks!