The traffic lights for eastbound traffic on 7th St between College Ave and Walnut Street are out-of-sync. Traffic is being held at both lights which does not allow traffic to clear both intersections.
I was facing East on Indiana 45 and turning left (North) onto Kinser Pike. I didn't make the green left turn arrow and ended up in the middle of the intersection waiting to make an unprotected left. My light turned red but oncoming traffic still had a green, the oncoming turn lane got a green arrow. I was unable to clear the intersection, was unable to back up with cars behind me, and was blocking traffic from Kinser Pike when they got a green light. This is dangerous, I had assumed that oncoming traffic also had a red and would stop (as it had been for years), I was starting to clear the intersection by making the left when I realized oncoming cars weren't stopping. A turn lane where unprotected turns are allowed should not get a red while oncoming traffic still has a green.
Signal gives a green left turn arrow to east bound traffic on East 3rd for a left turn onto Hillsdale every cycle even without cars in the turn lane.
White pedestrian walk light is out on the north east corner of 7th and college.
Please have the city traffic software programmers review this signal's program. It is basically ignoring the street sensors for westbound traffic on 3rd.
Traffic signal is flashing red in all directions.
Turn signals trigger although no cars are in turn lane.
At the intersection of E 3rd St & Hillsdale to the north & Woodscrest to the south, the traffic light is disproportionately lengthy for the traffic traveling on Hillsdale/Woodscrest. The majority of the traffic goes east/west on E 3rd St., yet the light stays red/green for an excessive amount of time relative to the traffic that passes in the respective directions.
The traffic signal at Bryan St at the intersection with 3rd and High Streets is not working properly. It does not cycle to green in sequence with the other streets unless the front car pulls forward into the crosswalk. This creates an unsafe situation for both pedestrians and drivers. Please fix the light so that it cycles properly with the signals for the other streets. Thank you.
The walk signal at the NW corner of 10th and Walnut facing south is burnt out. The don't walk signal lights up but the walk does not. Thanks!