closed #177644
Traffic Signals
515 S Patterson Dr, Bloomington, IN 47403, USA
- Case Date:
- 9/26/2021
Traffic light is cycling continuously. And left turn signal at Patterson westbound on to Fairview cycles every time as well
Traffic light is cycling continuously. And left turn signal at Patterson westbound on to Fairview cycles every time as well
Traffic signal at W. Patterson and Fairview St has been cycling ever 30 seconds for a couple weeks. And the left turn arrow for west bound Patterson turns green every cycle with no vehicles turning.
The signal seems to think that there is always traffic waiting on Fairview.
Patterson and Fairview light timing messed up. Constantly switching to red after about 10 seconds even with no traffic waiting on sensors
The traffic light on Patterson goes red after 1-3 cars pass through. This happens over and over again even though there are no cars on Farview. I have waited upwards of 7+ light cycles to get through this light. This delays drivers and increases pollution. This has been an issue for months, please fix the issue.
Traffic light at W. Patterson and S. Fairview has been cycling every 20 seconds for weeks.
The pedestrian signal on the northwest corner at the intersection of College and Kirkwoid does not show the white ok to cross figure when approaching from the east. I noticed this last weekend but forgot to report.
The pedestrian crosswalk buttons are not working properly at the intersection of 10th & Jordan this morning. In particular, the westbound crossing button on the southeast corner did not activate the pedestrian crossing light through several cycles at approx. 9:10am. I didn't confirm, but it looked like other buttons/directions were having similar problems. Was working fine yesterday.
None of the pedestrian crossing buttons have been working at the intersection of 10th and Jordan today. There is no way to activate the pedestrian signals.
10th and Jordan intersection: Westbound pedestrian crossing button on SE corner and northbound crossing button on SW corner are not working - red light above button remains on and walk signal is not activated. Problem has been happening for at least a week or so.