Traffic light on st.rd 46/Dunn street it was motion-sensitive during early morning hours(3:00am-6:00am),but after recent construction stop light start operate with day time options. Please adjust stop light in early morning with motion-sensitive option. Thanks.
the traffic light at the corner of high street and hillside drive (moose's pike) needs fixing. going south on high street, the arrow to go left (east) onto moose's pike ALWAYS activates, with no cars there. it stays a long time, disrupting traffic in all directions.
Traffic light out of sync
Last night a semi drove through the neighborhood. When they turned from W.7th Street to go south on Adams Street, they knocked over the stop sign located at the southwest corner of the intersection of 7th & Adams. It will need reset.
Traffic signals are not working
On several occasions I've pulled up to the left turn lane stop line going south on Henderson at Winslow and have not gotten a green light. I arrived at the intersection just as Henderson northbound is getting a green light and green turn arrow, and there are no cars yet at the red lights on Winslow. Once the northbound left turn traffic is done, the southbound light never goes green. So I sit and wait for an entire cycle before getting a green arrow three minutes later.
I've reported intermittent malfunctions at this light before. This time I was heading north bound on Henderson and stopped in the center lane at the red light for Winslow. The light was green both directions on Winslow at the time. The light then went red on Winslow and turned green with a green arrow for the south bound cars stopped on Henderson. After these cars went through, the traffic light went green again for Winslow and I never received a green light. The second time around, a car came alongside me in the left lane and I then got a green light after sitting for two plus minutes a second time around. The light is also set to green too long for Winslow.
The traffic signal at Bryan St at the intersection with 3rd and High Streets is not working properly. It does not cycle to green in sequence with the other streets unless the front car pulls forward into the crosswalk. This creates an unsafe situation for both pedestrians and drivers. Please fix the light so that it cycles properly with the signals for the other streets. Thank you.
At the corner of Rogers St and Graham Dr a push button for yellow blinking lights does not work. It is on the south-west corner of the intersection.
All of the traffic signals on the intersection of W 3rd Street and South Madison Street AS WELL AS W 3rd Street and South Rogers Street are NOT ON. It is as if they do not have any power.