Corner of Dunn and 3rd street, need to place an additional "no turn on red sign" next to signal light. Many people turn right onto 3rd street from Dunn in front of on-coming traffic.
I'm new to Bloomington, currently residing on S Park Ave, so I'm not sure if the following has already been reported. I often find it frustrating that there is not a 4-way stop on at the "intersection" of 2nd st and S Park Ave. This isn't a typical intersection as 2nd street dead-ends into S Park causing drivers to have to turn right or left to continue on 2nd, depending on their direction. I realize that 2nd street has more traffic than S Park however traffic often gets backed up when drivers don't know who has the right-away. I've witness several close calls. I'm just looking for some feedback to see if this has been investigated and/or if anything can be done to address it. Many thanks for your time and consideration!
I believe that the intersection of Hunter and Fess (one block North of the new Bloomingfoods store) should be changed from a 2 way stop to a 4 way stop. When travelling west on Hunter, it is very difficult to see any traffic coming up Fess (north bound) until you are completely in the street. This traffic on Fess does not stop today, while Hunter does stop. With the significant number of cars normally parked on Fess, it is very difficult to see oncoming traffic until you are nearly into the oncoming traffic lane. With the new Bloomingfoods, there seems to be a growing amount of traffic using Fess in this area. I regular use Hunter on my bicycle, and this intersection is the most dangerous one on Hunter, and would benefit from being converted to a 4 way stop.
Swain is no parking on both sides of the street between 3rd street and Atwater. And it is marked with 'No Parking Any Time' signs in several spots. There is one spot that people always park. Sometimes even going the wrong way. This spot is next to the Ami restaurant parking lot. This is especially dangerous when delivery trucks are parked on the other side of Swain delivering to Mother Bears. I've attached a photo to show cars parking in this spot. There is a sign in front of these cars, and another behind them. Where they are parked is a curb that has the entrance to the Ami parking lot to the front of them and to the back of them. They think since there is no sign on this part of the curb that they can park there. I would like to see a sign posted in this part of the curb. Having s sign posted in this part of the curb would eliminate most if not all of this parking.
I often bike north on Jordan avenue to 3rd St., then turn left onto 3rd with the traffic light. Before the recent construction, the left turn signal appeared to be on a timer, and now it seems to be activated by a metal-sensitive loop in the pavement. But so far I have been unable to trigger the left turn signal with my bicycle. I have been instructed to ride exactly on the wire, and I ride a steel frame bike from 1970, so it should have plenty of metal to be detected. Is there some way to make sure this traffic light actuator is sensitive enough to work for bicyclists as well as for cars?
Not really a "Traffic signal" but I couldn't find a "Sign" category: The "No Parking" sign in front of 1300 E. Southdowns Dr. was rammed and damaged by a fast-moving hit-and-run white panel truck at 2:30 pm today, 5/28/2014. Sign was bent and is now leaning. I heard the noise, saw the truck driving past, but did not notice identifying markings on the truck -- it may have been solid white. It had to be driving on the grass to do this damage.
Hi, I contacted the city last week about a stop sign on 2nd and Ballantine that is completely covered by a tree. It is a danger as it should be a 4 way stop, but people don't see it and will fly through it. Please get the tree trimmed so it doesn't cover up the stop sign. Thank you. Best, Ingrid
Pedestrian signal missing on the ne corner of Eagleson and Atwater crossing Eagleson
Pedestrian signal missing on the ne corner of Eagleson and Atwater crossing Eagleson
Hello, The stop lights at the intersections of Jordan and Atwater, and the intersection at 3rd and Jordan, are not synced. As a result, people driving to and from campus get hit by both stop lights. They used to be synced up with one another so drivers would make both lights if they were traveling east or if they were traveling west. Now, no matter what, you'll have to stop at one of them. Also, the green turn arrow light always comes on at the intersection of Jordan and 3rd, even if there is no traffic. This creates weird delays for people trying to leave campus. I know these complaints of mine are trivial, I'm not sure how much it would take to re-sync the stop lights. But I've worked on campus for years and it was perfect - now this happens and hundreds of people have to stop for 2 separate stop lights 4 or 5 times a day when it used to be zero stops.