There is are several crosswalks on Allen St. that are very hard to see at night. The lines could use reflective coating or blinking lights to help them be visible by car headlights at night.
Yesterday (Thursday 25 Sept) at 5:15pm, a Ford Bronco turned *North* (left) onto Dunn from 10th Street (against the one-way direction), traveled north at a high rate of speed several blocks, and then pulled into the parking lot of 820 N. Dunn. During this illegal maneuver, another car that was traveling south on Dunn (the correct direction) had to pull over to avoid a collision. The driver might not have known he was committing a violation because that intersection is not clearly marked "Do Not Enter". Maybe a sign should be put up there to make sure that careful drivers know it is one-way.
I live in the trailer court on Muller pkwy and every year with the influx of students I have been trying to turn left on to Muller pkwy and multiple times cars have come out on to 3rd Street trying to turn left ignoring the Do not enter sign I have almost been hit on multiple occasions. Then on Muller Pkwy itself students speed and do not pay attention to pedestrians and their dogs there isn't a sidewalk or speed bumps to slow we traffic down there isn't a speed bump until by the apartments complex Village at the Muller t
The light at 2nd and Patterson needs a longer left turn signal, going from Patterson onto 2nd street. The time of the turn light is way too short. This has been a problem for years. I was the 6th car back in the turn line this morning and had to wait THREE LIGHT CYCLES to even make it through. Please make it a turn signal longer. Thank you!!!!!!!!!!!!!!
Maybe it is just me, but it seems like installing signs and marking the new speed bumps on S. Washington would be a smart idea. The bumps that were installed blend in perfectly to the existing pavement, the paint is woefully inadequate to be visible under any conditions, and there are no signs indicating that there are bumps. People are being taken for quite the ride thanks to another phenomenal job by the city with a poorly implemented traffic calming device.
Westbound traffic on E Hillside congests at the S Walnut and E Hillside traffic light, which often causes backups and results in traffic blocking the E Hillside and S Washington intersection. Can there be a “do not block intersection” or one of the roadway painted Xs placed at that intersection? This has happened to me numerous times, and I get frustrated and honk, and E Hillside drivers either ignore me, or give me a mean look like this was my fault when they’re blocking the roadway.
I reside at 1909 E. Windsor Dr. Recently many of the streets in our neighborhood were repaved and speed humps were installed. However, our street from the corner of Arden Dr to the three-way stop corner of Wilton Dr were repaved but not speed humps. I am advocating for 1-2 to be installed on Windsor Dr between these two intersections. Very few autos stop at the three-way and I believe the speed hump will slow them down as they come to the Windsor & Wilton intersection and make for a much safer intersection. An older resident in the neighborhood explained how Windsor Dr at one time was a straight east-west street and the Windsor & Wilton intersection was a straight T with only one direction having a stop sign. The city, many years ago, changed this intersection to add a three-way stop and curve Windsor out so to slow down traffic. Maybe it worked, but not so much from our vantage point. I have small grandchildren that are with me a lot and I'd like the area to be safer for pedestrians. Lots of dog walkers and people walking in general and there are NO sidewalks for the most part in our neighborhood. Thank you for your consideration of this matter. Please feel free to contact me kjmstri41#gmail.com or 812-327-0995