Case Date:

9/27/2020

Traffic light works, but then stops & starts flashing yellow going east & west. Landmark turning East or west gets flashing red.

Case Date:

10/6/2020

I have been at the stoplight heading north on S. Walnut St. at the Rhorer Rd intersection twice lately and the stoplight does not register that you are waiting on the light to change. There must be something wrong with the sensor at this light. Thanks!

Case Date:

10/22/2020

pedestrian walk signal facing N College, pole located on NE corner of 6th and college. Don't walk works fine. Walk visible signal not seeming to work.

Case Date:

11/2/2020

This is a test.

Case Date:

11/10/2020

On several occasions I've pulled up to the left turn lane stop line going south on Henderson at Winslow and have not gotten a green light. I arrived at the intersection just as Henderson northbound is getting a green light and green turn arrow, and there are no cars yet at the red lights on Winslow. Once the northbound left turn traffic is done, the southbound light never goes green. So I sit and wait for an entire cycle before getting a green arrow three minutes later.

Case Date:

11/10/2020

The new pedestrian crossing signals on South Walnut are programmed to take too long. The flashing yellow takes too long and half the motorists come to a stop while others continue thru the yellow to beat it. This becomes dangerous because pedestrians see certain cars slowing and stopping and begin to cross. I've seen folks almost get hit. Then the lights go solid red, oftentimes after the pedestrians have already crossed the road. Then the flashing red is too long, confusing many motorists who can't read or understand the sign. The entire sequence needs to be shortened for safety sake.

Case Date:

12/1/2020

The vehicle sensors on Clarizz don't seem to be detecting correctly. I have set at that intersection, and the traffic signals take a long time to change, even if there's no traffic on 3rd Street. Wasn't sure if that is the way it is supposed to be or not.

Case Date:

12/4/2020

Light bulb is out on the Pedestrian Traffic light. Bulb that is out is facing East.

Case Date:

12/11/2020

I've reported this traffic signal problem before, it intermittently gives northbound Walnut a left turn arrow onto Hillside when there are no cars in the lane. Today, there were no cars at all going northbound and it still cycled a long 30second green left turn arrow with 10-12 cars waiting at the light going southbound.

Case Date:

12/11/2020

I've reported intermittent malfunctions at this light before. This time I was heading north bound on Henderson and stopped in the center lane at the red light for Winslow. The light was green both directions on Winslow at the time. The light then went red on Winslow and turned green with a green arrow for the south bound cars stopped on Henderson. After these cars went through, the traffic light went green again for Winslow and I never received a green light. The second time around, a car came alongside me in the left lane and I then got a green light after sitting for two plus minutes a second time around. The light is also set to green too long for Winslow.