The left turn arrow for westbound Winslow Rd at South Walnut cycles green every time when there are no cars turning left. Don't believe the loops were reactivated after construction this summer.
The light at High St and Hillside/Moores Pike has a left turn signal that is activating whether or not a car is present. It is the left turn arrow on southbound High St as you approach the intersection adjacent to the cemetery. This prevents cars heading north on High St from proceeding until the light cycles through the phantom left-hand arrow.
The street light is out and is in flash.
At the corner of Rogers St and Graham Dr a push button for yellow blinking lights does not work. It is on the south-west corner of the intersection.
Light indicating left turn onto park square drive and going straight is split in half on 3rd.
It's my question is about the street lights again on West 3rd Street how the timing is definitely , off so 3:30 in the afternoon no rush hour also at 10:00 at night you'll stop for a light as soon as you go the next one turns red so you basically stop at every light and during rush hour this causes traffic to back up through the intersections even when the light turns again the intersections are still full cuz the timing's off. You see lots of people running lights just so they don't get stuck at the next lights
Traffic light on IN 45/46 for this turning left onto E Matlock Rd is unattached from the cables holding it steady and not facing the traffic it is meant to direct.
A couple of times recently the light at sare rd/college mall has not detected my car in the east bound straight lane of sare rd. This appears to only happen at night. I usually end up there for a few cycles.
The traffic light at the intersection of Adams St and Bloomfield Rd/Second St. is improperly adjusted. There is very light traffic from Adams St, but the traffic signal is set as if Adams St had similar traffic as Second St/Bloomfield Rd. This problem causes needless traffic backups on Bloomfield Rd/Second St, resulting in increased pollution from vehicles sitting at the traffic signal when there is no traffic from Adams St. Please send someone to view activity at this location, and adjust the signal so that it changes only when there are vehicles waiting on Adams St.
Traffic light is operating from a timer, not traffic. I am experiencing this as the only car north/south in the mornings around 5:30a.m.; no cars east/west to trigger the signal