Case Date:

8/6/2019

The pedestrian crossing signal on the northwest corner of S. Rogers and W. Patterson is not operative.

Case Date:

12/2/2019

I'm assuming you're aware of this and repair is in progress, but just in case, the South Walnut and Grimes traffic light continues to cycle green when there are no vehicles in the northbound left turn lane and when there are no vehicles from either direction stopped on Grimes.

Case Date:

12/2/2019

Red light out on right side of pole at intersection of N. Adams and Kirkwood/W.3rd. Light for northbound traffic onto Adams from 3rd.

Case Date:

7/15/2019

Traffic light at Kirk wood and Adams stays on green for the west bound traffic bound traffic on Kirkwood for about 3 minutes while the other lanes back up. Especially Adams which backs up from Kirk wood to the B trail in the morning

Case Date:

1/3/2019

South Walnut and Hillside traffic light malfunctioning.

Case Date:

12/9/2019

When traveling north on Fee Lane when you reach Fee & 17th the left arrow turn does not come on.

Case Date:

11/24/2018

Prolonged traffice light timing on 3rd street and Landmark.

Case Date:

9/5/2019

The traffic signal for pedestrian at State Rd 46, North Kinser Pike intersection is broken on the second pole. It is getting difficult to cross the road.

Case Date:

10/5/2019

I'm not sure what's up with the pedestrian signal at High Street and Greenbriar Lane. It's been fixed at least twice in the last few months, but it is acting up again (flashing even when there are no pedestrians around to push the button). I appreciate the city's prompt response to the previous reports, but it would be nice if someone could figure out what the problem really is and fix it for good.

Case Date:

9/12/2019

The crosswalk signal on High at Wimbleton mystfies me. I would think it's supposed to work by having the lights off until someone pushes the button, and then it is supposed to flash for long enough for the person to cross the street after cars have stopped. Maybe I am wrong about this. I can't see any evidence that pushing the button has any effect at all, and I often see the lights flashing at random times when nobody has been around to push the button.