closed #184426
Traffic Signals
2501 E 3rd ST
- Case Date:
- 7/2/2023
Please have the city traffic software programmers review this signal's program. It is basically ignoring the street sensors for westbound traffic on 3rd.
Please have the city traffic software programmers review this signal's program. It is basically ignoring the street sensors for westbound traffic on 3rd.
At the intersection of E 3rd St & Hillsdale to the north & Woodscrest to the south, the traffic light is disproportionately lengthy for the traffic traveling on Hillsdale/Woodscrest. The majority of the traffic goes east/west on E 3rd St., yet the light stays red/green for an excessive amount of time relative to the traffic that passes in the respective directions.
The signal light at Third and Woodcrest always thinks there is a car turning left, even when both East and west traffic in the turn lane is empty
The pedestrian crossing buttons at all four corners of East Third Street and Hillsdale/Woodscrest aren't working. Pedestrians never get a walk signal. In addition, the traffic light stays green for Third Street car traffic until a vehicle pulls up on Hillsdale or Woodscrest to wait at the light (meaning pedestrians often must try to cross when there are drivers turning left across the crosswalk).
One more signal seems to be reset back to original settings.
The traffic signal at Bryan St at the intersection with 3rd and High Streets is not working properly. It does not cycle to green in sequence with the other streets unless the front car pulls forward into the crosswalk. This creates an unsafe situation for both pedestrians and drivers. Please fix the light so that it cycles properly with the signals for the other streets. Thank you.
Last night a semi drove through the neighborhood. When they turned from W.7th Street to go south on Adams Street, they knocked over the stop sign located at the southwest corner of the intersection of 7th & Adams. It will need reset.
Traffic light out of sync
Looked like the left turn bulb that faces west at 3rd and Smith was out last night. So turning from eastbound 3rd to n Smith
It seems like something has changed with the signal at Third and Smith. If you were on Smith, the light would change soon after you came to a stop especially when there’s little traffic (early morning for example). Now, it takes several minutes for the light to change and allow the Smith Road traffic to go even in light traffic times. This causes Smith Road to be even more backed up than usual. Wanted to see if ot could be set like it used to be. Thanks!