The vehicle sensors on Clarizz don't seem to be detecting correctly. I have set at that intersection, and the traffic signals take a long time to change, even if there's no traffic on 3rd Street. Wasn't sure if that is the way it is supposed to be or not.
The new pedestrian crossing signals on South Walnut are programmed to take too long. The flashing yellow takes too long and half the motorists come to a stop while others continue thru the yellow to beat it. This becomes dangerous because pedestrians see certain cars slowing and stopping and begin to cross. I've seen folks almost get hit. Then the lights go solid red, oftentimes after the pedestrians have already crossed the road. Then the flashing red is too long, confusing many motorists who can't read or understand the sign. The entire sequence needs to be shortened for safety sake.
On several occasions I've pulled up to the left turn lane stop line going south on Henderson at Winslow and have not gotten a green light. I arrived at the intersection just as Henderson northbound is getting a green light and green turn arrow, and there are no cars yet at the red lights on Winslow. Once the northbound left turn traffic is done, the southbound light never goes green. So I sit and wait for an entire cycle before getting a green arrow three minutes later.
This is a test.
pedestrian walk signal facing N College, pole located on NE corner of 6th and college. Don't walk works fine. Walk visible signal not seeming to work.
I have been at the stoplight heading north on S. Walnut St. at the Rhorer Rd intersection twice lately and the stoplight does not register that you are waiting on the light to change. There must be something wrong with the sensor at this light. Thanks!
Traffic light works, but then stops & starts flashing yellow going east & west. Landmark turning East or west gets flashing red.
When cars turn off of 10th st onto sunrise or in to the parking lot at teter quad, the light turns red for 10th st needlessly.
The crosswalk signal never changes to WALK. I stood on the NE corner of Kirkwood and Adams, trying to cross Kirkwood to go south toward Rose Hill. I pushed the button and watched through several cycles (for more than three minutes) and it never changed. It was the same way last Sunday, too.