Case Date:

1/9/2015

Lights are flashing yellow for Curry and red for Profile.

Case Date:

4/1/2015

A screw is off behind the pedestrian walk button.

Case Date:

1/4/2013

Turn arrow for northbound curry to westbound vernal comes on when no one is there.

Case Date:

2/1/2013

It's blinking red, but people on Curry aren't stopping or treating it like a three way stop.

Case Date:

8/19/2015

Signals are not responding ro traffic. Have to wait for light to change from west bound Curry when there is no one there in the first place.

Case Date:

9/18/2015

the left turn arrow for northbound walnut street at hillside activates without turn lane traffic present and stays activated for the full duration of it's maximum setting. the left turn arrow on third street at Patterson will not activate for motorcycles.

Case Date:

3/5/2013

traffic lights out

Case Date:

12/31/2019

The light at Jonathan Dr. and Curry Pike needs adjusted. Turns green for Jonathan Drive when no one is there. Especially early in the morning.

Case Date:

5/30/2023

signal at smith ave and walnut (by chocolate moose) has a bunch of bike & ped problems. It's not generally possible for me to get a green light to cross walnut by bike (is the bike sensor supposed to work? it doesn't). this morning, we got a green light but it only lasted 2 seconds! this is supposed to be a greenway! i am trying to get two kids across! also, the north south crosswalk signals (parallel to walnut) are generally red DONT WALK even when walnut's car signals are green. its been screwed up one way or the other for about 9 months, but it worked fine (recall mode for east-west traffic) last summer, at least at 8:30am and 4:30pm. anyways I'm teaching my 9 and 11 year olds the illegal idaho stop light and i wish i wasn't!!

Case Date:

9/1/2022

signal at smith and walnut (just north of seminary square) used to operate in some sort of recall mode, but this week has not been. as a cyclist i dont seem to have any way to activate the signal. i'm typically eastbound here and stopping in the middle of the bike rectangle there doesnt seem to have any effect. i have been running the red, which is unideal. thanks!