The traffic light at this intersection high st and hillside is not timed properly. When traveling east west, the light is very short and only allowed 8 to 9 cars to get through so the traffic is backing up very badly
The signals do not switch the lights when traffic is stopped in an east -west direction but no traffic is going is traveling in the north-south direction. Either the sensors are not working or the electronics is at fault.
This is a light which depends on a sensor, not timed. The sensor on High street (I believe the north side) seems to be permanently activated. This has adversely affected traffic.
The turn lights/arrows have been non-functional for months causing many close calls between pedestrians and vehicles, also causing back ups onto law lane where some people end up stopping on the railroad tracks. Please find a way to get these functional again, I'm afraid someone will be injured. Thank You
if one is heading north or south on union, the left turn signals ALWAYS go on with every cycle-- even when no cars are turning. the turn signals stay on for a long time. they should work only when a car is there to turn
The green light was burnt out for northbound traffic on Walnut Street at Miller Drive. It's the light for Walnut traffic heading south to north. The green light on the right side (furthest east) of the set of lights was out just after 8pm this evening when I passed through.
The light at the intersection of Union and 10th has a turn arrow. Last summer the turn arrow stopped working. I assumed it was due to reduced traffic from fewer students. But it's approaching a year and the arrow still does not work. P.S. There are potholes in the left turn lane on Union, turning East onto 10th. They make that turn really rough.
The traffic light at 10th and Union needs to have its sensors checked. Starting late last week, it stopped responding to the sensors in the road. It shows green for far too long on Union, which backs up traffic unnecessarily on 10th St. (This isn't due to increased cars on 10th St, but rather due to the light's short cycle.) At night, the light will run a full cycle even if there is no traffic and will not respond to cars idling over the road sensors. Thank you.
Traffic light at N. Union St. and E. 10th St. The light is green for N-S bound traffic on Union St. for much longer than traffic moving E-W on 10th. This is causing long and unnecessary backups on 10th St. This began a few months ago. Please look into adjusting the light timer.
*********2ND REQUEST******** uReport City of Bloomington, Indiana – John Hamilton, Mayor Login Cases Locations Report a problem open #156479 Traffic Signals: Other: Why are so many traffic lights now running 24 hour cycles instead of the yellow flashing late at night? Particularly troublesome lights are on South Walnut by the Herald Times, Henderson and Hillside, Lincoln and 3rd, Washington and 3rd. This switch was made about three weeks ago and is becoming quite annoying. Reported By Roger Kugler Assigned to Neil Kopper History 10/11/2016 9:02 am Andrew Cibor assigned this case to Neil Kopper Sent notification to Neil Kopper, Roger Kugler 10/11/2016 7:15 am Danna Workman assigned this case to Andrew Cibor Sent notification to Andrew Cibor, Roger Kugler 10/11/2016 5:55 am anonymous assigned this case to Danna Workman Sent notification to Danna Workman, Roger Kugler 10/11/2016 5:55 am Opened by anonymous