Left turn arrow for northbound Walnut Street at Hillside intermittently cycles green when no cars are turning left onto West Hillside. This doesn't happen every cycle, but I notice it about once a week when going through the intersection.
Traffic signals are not working
The traffic light at Bloomfield Rd (2nd Street) & Rolling Ridge Way is a problem during normal commuting hours (7:30am-8:30am & 4:30pm-5:30pm). In the morning, traffic comes to a crawl and is backed up from this intersection all the way to the exits of Highway 69, often blocking the Highway exits. The short trip between the Highway exits and this intersection would normally take less than 1 minute. During the morning commute hours, it takes 5+ minutes. A similar situation occurs in the evening. Westbound traffic comes to a crawl and is commonly backed up from this intersection to S Patterson Drive, or sometimes even farther. This traffic light is certainly the cause. After passing this light, the congestion is no where to be seen and traffic flows normally. My suggestion would be to alter the programming of this light, during these specific hours, to be much more heavily biased toward East-West traffic. Perhaps it could stay green for East-West traffic for 50% longer than standard, or similar.
About 5 minutes ago the traffic light was stuck on red in seemingly all 4 directions at the intersection of 17th and Madison/Kinser. One direction (east) may have had flashing red lights. We were all stuck for some time before people started going as if the lights were flashing red on all sides.
I have no idea how many times I’ve complained about this light. I wish the head of this department lived out this way and had to wait through a quarter mile backup while the light switched back and forth without any cross traffic. Quit putting a band-aid on it and fix it permanently
There are no lane markings for the Northside of Henderson and Winslow? Should there be at least temporary markings for the lanes until the construction is completed?
Why is there a missing school flasher near Fairview Elementary when the city made a press release today about the security the 16 new school zones will provide?
Why haven’t the cross walks been installed at Hillside/Moore’s pk and High Street?
The walk signals do not come up anymore. It is a constant red hand and there are no buttons to select a walk signal. Many pedestrians use this intersection and not having a clear signal to alert drivers is creating a dangerous condition.
several stop lights take to long to change. 2nd and Paterson, Paterson and Fairview 1 Minuit and 45 seconds. Other lights on Paterson are on timers instead of the sensors. Paterson and Fairview coming out of Catalent you have about 10 seconds to get threw it before it changes red again.