Case Date:

8/30/2012

Street sign at intersection of Sheffield & Plymouth has apparently been hit by a car (45 degree angle--no pedestrian or traffic hazard however)

Case Date:

2/25/2013

The crosswalk at 10th St. & Fee Ln is not working properly, and this is not related to building construction. Several weeks ago, the signal stopped allowing protected pedestrian right-of-way to pedestrians crossing 10th Street. The crosswalk button ceased functioning at the same time. This has been reported previously and it has not been resolved. Meanwhile, hundreds of people are daily risking their lives to cross the street, while being conditioned to ignore crosswalk signals.

Case Date:

2/28/2013

Sections of 10th street could use pedestrian crossings. 10th and Washington can be particularly difficult to cross on foot.

Case Date:

5/30/2013

Green arrow for right turn going from westbound 3rd st. to north bound bypass when left turn for southbound bypass to eastbound 3rd st. is out.

Case Date:

6/19/2013

The pedestrian crosswalk buttons are not working properly at the intersection of 10th & Jordan this morning. In particular, the westbound crossing button on the southeast corner did not activate the pedestrian crossing light through several cycles at approx. 9:10am. I didn't confirm, but it looked like other buttons/directions were having similar problems. Was working fine yesterday.

Case Date:

9/23/2013

None of the pedestrian crossing buttons have been working at the intersection of 10th and Jordan today. There is no way to activate the pedestrian signals.

Case Date:

9/25/2013

the traffic light at the 45/46 bypass and walnut street is malfunctioning. It only stays green for about 13 seconds for the east and west traffic on 46 and is causing large backups in the morning and afternoon. This seems to happen after the football games. Please take care of this issue and let traffic flow. It is to the point where the light at kinser pike turns green but there is no where to go because this light is backed up so badly.

Case Date:

10/28/2013

10th and Jordan intersection: Westbound pedestrian crossing button on SE corner and northbound crossing button on SW corner are not working - red light above button remains on and walk signal is not activated. Problem has been happening for at least a week or so.

Case Date:

5/14/2014

At SR46 and 10th St. While a train is crossing SR46 I saw two disfunctional aspects of the signaling. 1) The pedestrian crossing requests are totally ignored while the train is crossing SR46. Pedestrian signals stayed red until the train had finished crossing SR46. 2) Eastbound 10th never was given a green signal while the train was crossing SR46. There is no reason that this direction should be kept from crossing and several cars ended up crossing against a red light during the green signal for westbound 10th.

Case Date:

10/30/2015

We were traveling east on 10th St. this evening, approaching the bypass on the east side. While waiting for the red light to change to green, the train gate on the bypass lowered and a train approached also from the east. When a train is crossing the bypass, the light rightly does not allow traffic through from the north, as it would soon have nowhere to go. This is good. BUT it also did not allow our lane to travel through the intersection going east! I know there is no separate right-turn signal there to stop people from turning south onto the bypass, but it is not logical to stop all traffic going east as well. And besides, the light DOES allow westbound traffic on 10th Street to BOTH continue west AND turn south onto the bypass -- even though there is a separate signal there for the south-turn lane -- and those cars then are stopped by the crossing gate. This is really illogical, and should be remedied.