Case Date:

11/5/2025

Request for a crosswalk be painted at 11th and Fee crossing 11th. That's a heavily trafficked area and there's no crosswalk.

Case Date:

11/3/2025

Speed bumps/rumble strips. Pedestrian crossing light. I’ve been almost run over numerous times here in the crosswalk people are going 40 or 50 miles an hour—-very dangerous for pedestrians crossing.

Case Date:

10/10/2025

Need street-surface traffic direction arrows painted in the 2 lanes of S. Clarizz heading north. I have seen people make the right-hand lane into a left-hand turn onto East 3rd St. Please see pic of suggested arrows. The yellow marks are the direction available besides a right turn. Tx!

Case Date:

10/8/2025

There is are several crosswalks on Allen St. that are very hard to see at night. The lines could use reflective coating or blinking lights to help them be visible by car headlights at night.

Case Date:

10/3/2025

The light at 2nd and Patterson needs a longer left turn signal, going from Patterson onto 2nd street. The time of the turn light is way too short. This has been a problem for years. I was the 6th car back in the turn line this morning and had to wait THREE LIGHT CYCLES to even make it through. Please make it a turn signal longer. Thank you!!!!!!!!!!!!!!

Case Date:

10/1/2025

I witnessed a woman get struck by a pickup truck today at E 3rd and Morningside. This was an accident waiting to happen, as pedestrians and bicyclists on E 3rd Street are constantly risking their lives to cross it. The distance from the crosswalk at Smith Rd to the traffic light at SR 446 is 0.5 miles. (Note, there are also ZERO pedestrian crossing marks at the very busy intersection of 3rd & 446, where people with kids cross to get to Bruester's Ice Creamery.) HUNDREDS of rental units have been built on both sides of 3rd between Park Ridge and 446. A SAFE crossing should be added, with flashers or center island at Park Ridge or Morningside, or a traffic light should be placed at 3rd and Park Ridge.

Case Date:

9/30/2025

Westbound traffic on E Hillside congests at the S Walnut and E Hillside traffic light, which often causes backups and results in traffic blocking the E Hillside and S Washington intersection. Can there be a “do not block intersection” or one of the roadway painted Xs placed at that intersection? This has happened to me numerous times, and I get frustrated and honk, and E Hillside drivers either ignore me, or give me a mean look like this was my fault when they’re blocking the roadway.

Case Date:

9/27/2025

Drivers going east on third make a U turn to get going back west on Third Street. They seem unaware of drivers on Peter Ellis also turning west onto Third. One driver went across both lanes making the U turn. Needs a NO U TURN SIGN.

Case Date:

9/26/2025

Yesterday (Thursday 25 Sept) at 5:15pm, a Ford Bronco turned *North* (left) onto Dunn from 10th Street (against the one-way direction), traveled north at a high rate of speed several blocks, and then pulled into the parking lot of 820 N. Dunn. During this illegal maneuver, another car that was traveling south on Dunn (the correct direction) had to pull over to avoid a collision. The driver might not have known he was committing a violation because that intersection is not clearly marked "Do Not Enter". Maybe a sign should be put up there to make sure that careful drivers know it is one-way.

Case Date:

9/24/2025

This four-way stop intersection has a very wide approach. Despite there being no visible lane markings, save for a faded arrow on the southbound approach on S Auto Mall Rd to this intersection, drivers frequently make their own rules and act like there are two lanes or just one. I don't even know what the proper lane configuration here is, but there should be clear markings and repaving done to this stretch from College Mall to S Auto Mall on Covenanter Drive. Speeds are low, but this intersection clearly needs an overhaul. It's been like this for years now, so I'm flagging this for relevant city departments.