Case Date:

2/20/2015

Pedestrian signal at 10 & Union has at least two non functional buttons.

Case Date:

2/21/2015

The housing to the red beacon at Rhorer and Old 37 is broken. There are two large pieces lying somewhat in the intersection. Light is still functioning.

Case Date:

2/22/2015

At the intersection of 10th and Union Streets, on the east side of the intersection, the Walk/Don't Walk sign is stuck on the Don't Walk symbol. Even when the light for motorized vehicles changes and when the button is pushed on the pole for the traffic lights, the Don't Walk symbol never goes away.---Thanks very much--Kirk Lundy

Case Date:

2/23/2015

cross walk light only works part of the time

Case Date:

2/27/2015

For several days, it has been impossible to activate the pedestrian walk signals for the crosswalk across 10th St on the west side of the 10th and Jordan intersection. After pressing the button on either side of the crosswalk, the Walk signal never activates through multiple cycles. The small red lights above the buttons remain illuminated.

Case Date:

3/2/2015

Turn signal always turns on, whether or not someone is in that lane.

Case Date:

3/10/2015

Traffic signal not working properly at East 10th street and North Union. This signal is cycling through incorrectly and backing up eastbound traffic to Jordan Ave during peak times.

Case Date:

3/11/2015

The traffic light at 10th and Union needs to have its sensors checked. Starting late last week, it stopped responding to the sensors in the road. It shows green for far too long on Union, which backs up traffic unnecessarily on 10th St. (This isn't due to increased cars on 10th St, but rather due to the light's short cycle.) At night, the light will run a full cycle even if there is no traffic and will not respond to cars idling over the road sensors. Thank you.

Case Date:

3/13/2015

The pedestrian crosswalk lights at 10th and Jordan are not turning to walk when it seems like they should be.

Case Date:

3/13/2015

The pedestrian signals for the N-S crosswalk across Jordan Ave. on the west side of the 10th and Jordan intersection are not working. After pressing the button, the Walk signal never activates through multiple cycles. The small red lights above the buttons remain illuminated. I previously reported this two weeks ago on Feb. 27, so I wanted to make sure you were aware that this signal is still malfunctioning. I have seen (and been a part of) several near misses between vehicles and pedestrians that were at least partly a result of there being no Walk signal. Thanks for looking into this.