At the intersection of E 3rd St & Hillsdale to the north & Woodscrest to the south, the traffic light is disproportionately lengthy for the traffic traveling on Hillsdale/Woodscrest. The majority of the traffic goes east/west on E 3rd St., yet the light stays red/green for an excessive amount of time relative to the traffic that passes in the respective directions.
The traffic signal at Bryan St at the intersection with 3rd and High Streets is not working properly. It does not cycle to green in sequence with the other streets unless the front car pulls forward into the crosswalk. This creates an unsafe situation for both pedestrians and drivers. Please fix the light so that it cycles properly with the signals for the other streets. Thank you.
The walk signal at the NW corner of 10th and Walnut facing south is burnt out. The don't walk signal lights up but the walk does not. Thanks!
The turn lights are very short. They only let maybe 3 cars through before it changes. This is especially an issue in the mornings when traffic is heavy. The worst light is when you pull out of Kroger and head towards 45 bypass
I'm with the IU Grounds Crew, I received a report that the light at 10th and Fee is completely out.
I was facing East on Indiana 45 and turning left (North) onto Kinser Pike. I didn't make the green left turn arrow and ended up in the middle of the intersection waiting to make an unprotected left. My light turned red but oncoming traffic still had a green, the oncoming turn lane got a green arrow. I was unable to clear the intersection, was unable to back up with cars behind me, and was blocking traffic from Kinser Pike when they got a green light. This is dangerous, I had assumed that oncoming traffic also had a red and would stop (as it had been for years), I was starting to clear the intersection by making the left when I realized oncoming cars weren't stopping. A turn lane where unprotected turns are allowed should not get a red while oncoming traffic still has a green.
The signal light at Third and Woodcrest always thinks there is a car turning left, even when both East and west traffic in the turn lane is empty
Traffic light out of sync
The traffic light is down and it caused a huge traffic
It seems like something has changed with the signal at Third and Smith. If you were on Smith, the light would change soon after you came to a stop especially when there’s little traffic (early morning for example). Now, it takes several minutes for the light to change and allow the Smith Road traffic to go even in light traffic times. This causes Smith Road to be even more backed up than usual. Wanted to see if ot could be set like it used to be. Thanks!